Automatic Ball Valve
General Introduction
● Well waterproof and dustproof features (IP65).
● Actuator can not be affected by temperature of valve and environment.
● Quick and easy replacement of moving actuator.
● The actuator can be installed after the application and pipe was fixed that is efficient for installation.
● Valve can be mounted near to wall because of actuator’s off-center configuration.
● Valve can be operated by general tools when actuator has been removed.
● The actuator is available for all of 1/2″－1 1/4″ ball valves.
● Actuator installation allows for 2 different wiring orientations, thus providing ease of wiring and service.
● High Differential pressure up to 1MPa and strict closure
● High flux and no sediment due to direct flow through of valve.
● Soft shut-off and open, to eliminate water hammer in most applications.
● Motor don’t bear any forces when valve is not in motion, extending service life.
Specification
Medium: Cool/heat water or 60% glycol
Caliber: DN15，DN20，DN25，DN32
Structure: Two way or Three way
Operating Mode：On/off or 3-point control (24VAC)
Power Supply：AC110V，AC220V，AC24V etc.
Power Consumption：5W (during valve position change)
Running Times：15 sec.
Pipe Fitting：NPT internal thread
Optional: BSPP external thread
BSPP internal thread
BSPT internal thread
compression external thread
Material
Body：forged brass, nickel plated
Ball：chrome plated brass
Stem：brass
Seats：fiberglass reinforced teflon PTFE
Seal：2 EPDM O-rings, lubricated
Pressure Rating：2MPa
Media Temp. Range：34°F to 203°F (1°C to 95°C)
Max. Differential Pressure：1MPa
